I have made various mods over the past year and a bit, but have always just attached the costume power disc to the figure with double-sided tape.
Can you modders out there tell me how I can open the power disc to remove the little data sticker, so i can add it directly into the modded figures base? I have warmed it and tried gently prizing off the top with the image on it, but all i seem to be doing is damaging the disc artwork. Any tips please? I want to get my get figures as 'passable' as possible.
edit: Bit the bullet with BRUTE FORCE and answered my own question -
If anyone's interested ?...
Just heat the disc in warm water to make it pliable, then put both thumbs beneath the disc, and with your index and middle fingers either side 'bend' the disc. The red plastic part of the disc beneath the picture sticker will begin to raise. I used a knife to 'grab' the initial lift, then prized it off. Be careful not to damage the 'data sticker' beneath.
I'm probably talking to myself...